- Home
- Solar & Batteries
Everything we do sits on a roof or in a switchboard.
Annergy is an electrical contractor that specialises in solar. The people who design your system are the people who install it, and the people you ring in 2032 when something needs looking at.
Solar for Brisbane homes
Most Brisbane homes land between 6.6 kW and 13.2 kW. We work out which by reading your interval data, not by asking how many bedrooms you have.
- Tile, Colorbond, Klip-Lok, terracotta and multi-pitch Queenslander roofs
- Jinko, HT-SAAE, ET Solar, Akcome and Seraphim panels
- SMA, Fronius, Sungrow, Growatt and Huawei inverters, matched to your shading
- East–west splits where your usage peaks morning and evening
- Salt-mist-rated racking as standard bayside
- Switchboard upgrades and meter coordination handled in-house
Typical residential range
Most installs, start to switch-on
Panel product warranty
Annergy workmanship warranty
How we spec a battery
- Usable capacity first: sized to your evening load, typically 10 to 20 kWh
- Matched to your inverter: hybrid or AC-coupled, whichever suits your existing setup
- Rated for a Queensland garage: chemistry and enclosure chosen for summer heat
We only fit batteries on the Clean Energy Council approved list, so every system we quote is eligible for the federal battery discount. We are not tied to a single brand. We recommend what fits your load and your inverter.
Keep your afternoon sun for the evening
Exporting at 5c and buying back at 33c is a bad trade. A battery closes that gap, and with the federal discount, the maths finally works for a lot of Brisbane households.
- Blackout backup wired to your essential circuits, or the whole house
- Retrofit to an existing array, including systems we did not install
- VPP-ready if you want to join one, and no pressure if you don't
- An honest payback figure before you commit, even when it is a long one
Small commercial, up to 30 kW
We specialise in smaller systems, and small commercial is where they pay best: a shop, clinic or childcare centre uses most of its power in daylight, so almost everything the array makes is consumed on site rather than exported at 5c.
- Shops, clinics, childcare, offices, workshops and light industrial units
- Half-hourly load analysis so the array is sized to your trading hours
- Instant asset write-off and depreciation position explained in the proposal
- Energex negotiation for export limits and connection approvals
- Installed around your trading hours, usually in a single day
Typical commercial outcome
Year payback, typical
Cut to annual energy spend
Ranges reflect systems we have commissioned across SEQ. Your proposal will carry your own modelled figures, built from your retailer's interval data.
What we actually put on your roof.
We are not locked into one manufacturer. These are the panel and inverter brands we buy and install, and we will tell you which of them suits your roof and your budget rather than pushing whatever we have in the warehouse.
Solar panels
- Jinko Solar: the largest maker by volume, strong value per watt
- HT-SAAE: Shanghai Aerospace Automobile Electromechanical
- ET Solar: ET Solar New Energy
- Akcome: Akcome Optronics Science & Technology
- Seraphim: Jiangsu Seraphim Solar System
Inverters
- SMA: German-built, the long-service benchmark
- Fronius: Austrian, excellent monitoring and local support
- Sungrow: strong hybrid range for battery-ready systems
- Growatt: good value on straightforward roofs
- Huawei: optimiser-based, strong on shaded or multi-pitch roofs
Every panel and inverter we fit is on the Clean Energy Council approved product list, which is what makes your system eligible for the STC rebate. Your quote names the exact model going on your roof, never just “tier 1”.
EV charger installation
A 7 kW single-phase or 22 kW three-phase wall charger, wired so it prefers your own solar over grid power, including the Fronius Wattpilot.
- Solar-diverting configuration so you charge on your own generation
- Load management so you don't trip the main switch
- Switchboard and supply upgrades where needed
Repairs, servicing & rescues
Plenty of Brisbane systems were sold by companies that no longer exist. We will take on your system whether or not we installed it.
- Performance health check with a written report, $189
- Inverter fault diagnosis and replacement
- Isolator, DC cabling and roof-penetration remediation
- Panel cleaning and post-storm damage assessment for insurance
Tell us your address and your bill. We'll work out the rest.
A free assessment takes about 40 minutes and ends with a fixed-price quote, or an honest recommendation to wait, if that is what the numbers say.